Suomi - Finnish
  • Oxsa Snow 285 Push & Pull
    OXSA SNOW 285 PP

    Snow 285 PP is designed specially for blowing the thick snow.

  • Oxsa Snow 285 PP - Reversing accessory
    Reversing accessory

    With reversing accessory, you can drive already cleaned area.

OXSA SNOW 285 PP

OXSA Snow 285 PP
Oxsa Snow 285 PP - takaaOXSA SNOW 285 PP - edestäOXSA SNOW 285 PP - sivulta

 

For the unbroken blanket of snow

OXSA Snow 285 pp (push & pull) Is designed special for blowing thick snow. By using reverse with snow blower, it gives better ability of advancement in thick snow for your tractor, because you can drive at the already cleaned area. As an accessory you can choose reduction gear in both sides of the snow blower. Like in original Snow 285 there is a base under the throwing wings, it will protect the wings from the rocks or any other surprise obstacles.

Designed and produced in Finland for Nordic winter

Like all OXSA SNOW - family snow blowers, SNOW 285 pp is also made to withstand stress in demanding environment. To ensure this, all its parts are slightly "over" measured. At the frame where the stress is at the highest, we use S355 structural steel and places where items expose to a lot of wear - like blades - we use HB500 special steel. This ensures long life, structurally stronger quality products which serve its owner as long as possible.

The challenge of slush and wet snow is also taken into account at design. Which we can say by the response from field that OXSA SNOW 285 also works nicely in mild weather.

OXSA SNOW 285 pp is available only with 2 hatch model.

 

   Watch SNOW 285 PP in action

   Download SNOW 285 PP brochure

   Find closest retailer

Product properties

OXSA SNOW 285 PP - Properties

OXSA SNOW 285 - Rotor & chamber

Accessories

  • Hydraulic bank cutter for left side
  • Hydraulic bank cutter for right side
  • Bank cutter's rubber blade. Expand working width for 60 cm
  • Front and back legs grader that will roughen the leg track
  • Smooth blade
  • Tooth blade
  • Speed reducer gearbox for 1000 rpm power take-off (PTO)
  • Front wheels
  • Back blade

 

SNOW - Accessory Bank Cutter; which adds working width for SNOW 250 up to 370 cm and SNOW 285 up to 402 cm!
SNOW - Accessory: wheels.
SNOW - Accessory Front and back sled leg roughener. After roughener the sled track will not be slippery.

 

   Watch video of wall cutter (in Finnish)

Technical information

 SNOW 285 PP
Working width, cm282
Working width w. cutters, cm282 + 60 + 60 = 402
Clearing width, cm270
Weight, kg1430 kg
Rotor diameter, mm1000
Infeed wings8 (HB500)
Throw wings4 (HB500)
Speed reducer gearbox540 rpm / 1 ¾”
Bearing 
 At front70 mm
 At back75 mm
Throwing opening, mm360 x 360

OXSA SNOW 285 PP technical measure points

Snow blowers pivot shaft must be 1¾ Z=6 and equipped with 1400 Nm overload switch (breaker bolt or disk switch). Recommeded power requirements are 95 hp / 540 rpm or 150 hp / 1000 rpm. Matching pivot shaft can be ordered with the product.